HI Mark - This is an easy prop to fabricate… All it takes is about 6' of a 1-1/2" closet rod, an 8" x 8" piece of 1/2" plywood and 4 pieces of 1x3 at least 25" long, some glue and your preference to secure the pieces to the plywood. Cut ½" slots in the closet rod and 1x3 as shown in the PDF. Cut the curved "tines" as shown in the 1x3, angle the "tines" for a snug fit and assemble… This won't is as historically accurate as a bentwood folk but with a little distressing and rehearsal it should fit the bill and is easy on the budget. - I attached a sketch that gives the rough dimensions
------------------------------
Don Keith
Set Designer | Partner
The KEILIN Group | KL two
300 north pottstown pike, suite 140
exton, PA 19341
o: 610.873.2506
www.keilingroup.comwww.kltwo.comdon@keilingroup.com------------------------------
Original Message:
Sent: 01-14-2019 17:47
From: Mark A. Zimmerman
Subject: Pitchforks for BIG FISH
Where does one get the wooden (i.e., safe) pitchforks for BIG FISH?
------------------------------
Mark A. Zimmerman,
Theatre Director
Akron School for the Arts
Firestone Community Learning Center
470 Castle Blvd
Akron, Ohio 44313
Troupe 5570
mzimmerm@apslearn.org
------------------------------